3D printed cupholder

[martyn92]

Hi all,

Just looking to see if there would be any interest in a 3D printed cup holder.

I've made one to fit behind the handbrake when you remove the old tray. 
 
   

It will comfortably hold a normal sized 330ml can but not anything wider

Now, it is 3D printed at home and the results will vary with some minor defects on each one mainly the top surface. It may get better over time once I make a few changes to the printer.
Hopefully they will look closer the holder on the left but wont be any worse than the one on the right.

   

I'd be looking for £13 posted. Please bear in mind it takes 2 hours to print plus materials.

Any thoughts good or bad welcome!
Martyn