|
306 design "improvements"
|
12-04-2018, 01:43 PM
I would have designed it so the lower engine mount bracket didn't have the sodding drive shaft running through it (on XU's at least. Not sure if other engines had the same issue). Makes changing the mount a much bigger job than it should be, especially with those stupid bolts that hold the driveshaft bearing in place!!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
306 design "improvements" - by Magenta Sunset - 08-04-2018, 06:54 PM
RE: 306 design "improvements" - by Ben_w - 08-04-2018, 07:09 PM
RE: 306 design "improvements" - by Piggy - 08-04-2018, 07:39 PM
RE: 306 design "improvements" - by Poodle - 12-04-2018, 12:02 PM
RE: 306 design "improvements" - by cpikey316_ - 08-04-2018, 08:18 PM
RE: 306 design "improvements" - by Eeyore - 08-04-2018, 08:35 PM
RE: 306 design "improvements" - by Magenta Sunset - 09-04-2018, 08:17 AM
RE: 306 design "improvements" - by Rippthrough - 09-04-2018, 02:13 PM
RE: 306 design "improvements" - by Magenta Sunset - 12-04-2018, 12:54 PM
RE: 306 design "improvements" - by Mighty306 - 12-04-2018, 01:43 PM
RE: 306 design "improvements" - by Piggy - 12-04-2018, 07:36 PM
RE: 306 design "improvements" - by Ben_w - 12-04-2018, 07:49 PM
RE: 306 design "improvements" - by RetroPug - 12-04-2018, 09:36 PM
RE: 306 design "improvements" - by Orta - 14-04-2018, 10:10 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Design fault on ph3 | Jukie88 | 22 | 8,914 |
24-04-2018, 07:44 PM Last Post: Orta |
|
| Club Improvements | Niall | 34 | 21,353 |
13-11-2016, 10:16 PM Last Post: Piggy |
|
| do we have club flyers/would anyone want to design some? | Magenta Sunset | 13 | 3,990 |
31-10-2016, 06:43 PM Last Post: Dum-Dum |
|
