|
Fitting an ml6
|
Posts: 4,604
Threads: 90 Joined: Dec 2011 Reputation: 54 Location: Cornwall Car Model/Spec: 1996 306 DT M-TDI/16 
Thanks: 0
Given 20 thank(s) in 18 post(s)
03-07-2017, 12:17 PM
Problem I found was there just wasnt room there behind the motor to put a cylinder directly on the bulkhead.... Although things may differ with other motors. But mine is at 15 degrees and still not nearly enough room there...
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia | ![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fitting an ml6 - by madmadmax - 18-02-2017, 03:02 PM
RE: Fitting an ml6 - by allye - 18-02-2017, 08:01 PM
RE: Fitting an ml6 - by welshpug - 18-02-2017, 09:34 PM
RE: Fitting an ml6 - by zx_volcane - 19-02-2017, 06:52 AM
RE: Fitting an ml6 - by madmadmax - 26-02-2017, 04:03 PM
RE: Fitting an ml6 - by welshpug - 26-02-2017, 04:11 PM
RE: Fitting an ml6 - by madmadmax - 03-03-2017, 10:10 PM
RE: Fitting an ml6 - by madmadmax - 10-03-2017, 06:37 PM
RE: Fitting an ml6 - by madmadmax - 02-04-2017, 06:53 PM
RE: Fitting an ml6 - by allye - 03-04-2017, 10:51 AM
RE: Fitting an ml6 - by madmadmax - 03-04-2017, 07:23 PM
RE: Fitting an ml6 - by zx_volcane - 04-04-2017, 05:32 AM
RE: Fitting an ml6 - by madmadmax - 04-04-2017, 08:13 PM
RE: Fitting an ml6 - by ronj - 06-04-2017, 08:52 AM
RE: Fitting an ml6 - by madmadmax - 02-06-2017, 06:05 PM
RE: Fitting an ml6 - by madmadmax - 02-07-2017, 04:43 PM
Fitting an ml6 - by bashbarnard - 02-07-2017, 05:38 PM
RE: Fitting an ml6 - by madmadmax - 02-07-2017, 09:36 PM
RE: Fitting an ml6 - by welshpug - 03-07-2017, 09:45 AM
RE: Fitting an ml6 - by darrenjlobb - 03-07-2017, 12:17 PM
RE: Fitting an ml6 - by madmadmax - 04-07-2017, 05:15 PM
RE: Fitting an ml6 - by welshpug - 04-07-2017, 07:50 PM
RE: Fitting an ml6 - by darrenjlobb - 04-07-2017, 09:28 PM
RE: Fitting an ml6 - by madmadmax - 17-10-2017, 07:19 PM
|
