30-05-2016, 08:10 AM
So bottom engine mount done - found a new tool for the job 
A hole saw.... Use that to cut out the middle of the old stock mount, leaving you to just cut the old outer case in half and it just taps out. What was an hours job for me, only took 1/2 hour. Now I have a nice firm polybush lower.
The passenger side wishbone has also been done. Just waiting on the other 2 mounts to come in the post now
So I might get chance to start cleaning the interior, make her all nice and clean again
A hole saw.... Use that to cut out the middle of the old stock mount, leaving you to just cut the old outer case in half and it just taps out. What was an hours job for me, only took 1/2 hour. Now I have a nice firm polybush lower. The passenger side wishbone has also been done
. Just waiting on the other 2 mounts to come in the post now So I might get chance to start cleaning the interior, make her all nice and clean again
Not always Grumpy!!
306 Cabby SE, 2.0l 16v
To the optimist, the glass is half full. To the pessimist, the glass is half empty. To the engineer, the glass is twice as big as it needs to be!