Rear caliper yoke bolt spec

[powerandtorque]

spec is, from a 205 page on servicebox: diam 12x150-79

79mm long seems a bit big? but the M12 and pitch sounds about right.

That's because 440530 is the bolt that holds the caliper to the trailing arm, not the one that you're after which if I've understood correctly is the two that holds the pad carrier to the caliper body, correct?

That's more like about 20-25mm long but I can't see it listed anywhere on Servicebox as you've found. I can double check later for you if required though as I've got a caliper in pieces in the garage so have one of those bolts available to measure.