01-02-2016, 09:16 PM
(This post was last modified: 01-02-2016, 09:17 PM by pug306driver.)
I just refitted the front trim panel that covers the bonnet release mech, at the bonnet end, and it has a cast on end from memory ( it was only a few hours ago and I cant remember exactly fgs ) .
The cable is a multi strand wire.
Does the cabin end have a round nipple like a bike brake cable nipple??
If so, you may be able to feed a long one of those into the inner cable, and sort at the bonnet end??
I bet the new complete cable is a PITA to fit?
The cable is a multi strand wire.
Does the cabin end have a round nipple like a bike brake cable nipple??
If so, you may be able to feed a long one of those into the inner cable, and sort at the bonnet end??
I bet the new complete cable is a PITA to fit?