Daze's Ph1.5 (Ph2 converted) DTurbo

[Dazecoop]

Exactly what I have done with my ph3. I just need a ph1 rear bumper with the black rub strip to complete mine

Yours is looking great!!

It's not the fog light it's the reverse light, I always do this mod too, looking good btw,

You sure? It might have been! Very easy "mod" for sure! And thanks

- - -

Had some free time today and thought I'd remove wiper motor & clean the area below it in order to stop future leaks. Mine wasn't leaking & wasn't blocked, but I thought I might as well do it now as I had some free time.

So I've read, leaves gather below the wiper motor, proceed to block the drain hole, then you get horrible water in drivers footwell. Its a yearly, or maybe once every couple year job to do, and doesn't take very long.

I've actually also just written all this up & photos into its own guide, so people can find it easier in the future
http://306oc.co.uk/forum/showthread.php?tid=32886

Remove wipers (remove cap then 13mm nuts). Then remove driver & passenger plastic scuttle trims


Need to remove this triangular brace thing. x3 13mm bolts


Looks like this. Now go ahead and remove the x4 10mm bolts around wiper motor, and the final 10mm bolt holding the passenger side wiper stub/spline on


Disconnect wiper plug, remove entire thing, and it looks something like this. Horrible!


Pick out leaves & stuff. Put some lock on steering, and you can chuck water/brake cleaner in the area to flush everything out. The hole at the bottom comes out on top of the wheel arch liner, with some lock on, you can poke your figure through to clear it all out


Re-fit everything in order. I cleaned up the brace too, and copper-greased all bolts


Job done Check wipers work once its all back together & plugged in