So yesterday had a couple of hours to start on the pug most of the time was spent taking the front bumper off (due to undoing the bolt for the slam panel instead and not being able to notice the other 10mm bolt.
Got the fans out ok but leaning over on my hand on the rad accidentally snapped this ?. Rad on its way with single 12inch slim line fan and paint to re do front bumper grill and bonnet.
Today's job weather dependant take tmic off manifold a turbo ready for td04 and xantia manifold. Been reading and watching a you tube clip by piggy is loosening removing the top engine mount make it a lot easier and accessible ? And is there anything I need to be careful of?
Just to point out my diy skills are limited to basic servicing so apologies if I ask stupid questions or seem a retard
Got the fans out ok but leaning over on my hand on the rad accidentally snapped this ?. Rad on its way with single 12inch slim line fan and paint to re do front bumper grill and bonnet.
Today's job weather dependant take tmic off manifold a turbo ready for td04 and xantia manifold. Been reading and watching a you tube clip by piggy is loosening removing the top engine mount make it a lot easier and accessible ? And is there anything I need to be careful of?
Just to point out my diy skills are limited to basic servicing so apologies if I ask stupid questions or seem a retard