16-11-2015, 11:41 PM
(This post was last modified: 16-11-2015, 11:44 PM by daveylennon93.)
If i was you id bring rusty parts back to bare clean steel with a wire wheel and etch prime them parts.
No not that hard done once you get setup on a clean bench with all parts cleaned and tgat. Ill get you the link for rebuild.
Aye they'l boost that happy enuf for a good while, 2 bar is when it gets fun ☺
Without hdi rods your just waitin to hear a bang and see a hole in the block at that boost ☺
Link pump build:
http://www.brick-yard.co.uk/forum/ve-inj...17456.html
Link for uploadin pics:
http://306oc.co.uk/forum/showthread.php?tid=29024
No not that hard done once you get setup on a clean bench with all parts cleaned and tgat. Ill get you the link for rebuild.
Aye they'l boost that happy enuf for a good while, 2 bar is when it gets fun ☺
Without hdi rods your just waitin to hear a bang and see a hole in the block at that boost ☺
Link pump build:
http://www.brick-yard.co.uk/forum/ve-inj...17456.html
Link for uploadin pics:
http://306oc.co.uk/forum/showthread.php?tid=29024
HDI D'Turbo Daily Driver ---- XUD D'Turbo Project