31-10-2015, 12:47 PM
they will fit in a 5 door as i've done it with S16 half leathers however . . . . . i changed the subframe on the passenger side and it ends up about an inch higher, you really don't want that drivers side so i retrimmed the seat onto a 5 door frame, gotta admit i giggled a little at you fitting the backs and then saying you couldn't be arsed with the fronts, they are the ones that take the time, backs take 10 mins lol . . good luck with it, if you get stuck just ask, it's been a few years since i did it but i'll try and remember . . 
oh and forgot to mention, if you're not retrimming them you'll require a grinder . . .
oh and forgot to mention, if you're not retrimming them you'll require a grinder . . .
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs