10-06-2015, 08:17 PM
Decided to get this in the air eailer today, just as ash come round to have a nosey
![[Image: DSC_0462_zps7mnazj5p.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0462_zps7mnazj5p.jpg)
Tried to get locking wheel nuts off and immediately snapped the locking wheel nut key
but because ash was here he helped smash a socket over them and get all four out.
I poked around with a screw driver found loads of rust here there and every were (nothing that can't be fixed) then left it to have dinner.
Few hours later was board so decided to have another play and a hour and half later it was all stripped down.
![[Image: DSC_0464_zpsyllwhwa7.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0464_zpsyllwhwa7.jpg)
![[Image: DSC_0466_zpsu3eyazot.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0466_zpsu3eyazot.jpg)
So list that it needs are as follows
2x tyres
Front and rear wishbone bushes
1 ball joint
Clutch (new one was with car)
Drivers side wheel bearing
plenty of welding
Front indicator
Front arch guards (is no arch guards an mot fail???)
Think that's everything but no doubt something else will crop up.
So plans are fit the gt20 off ash's estate with my arp's and just run a low tune so I don't kill clutch, hopefully make it alot more drivable with a gt20 on.
And hopefully get all this done before pugfest.
Comments welcome
![[Image: DSC_0462_zps7mnazj5p.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0462_zps7mnazj5p.jpg)
Tried to get locking wheel nuts off and immediately snapped the locking wheel nut key
![Angry Angry](https://www.306oc.co.uk/forum/images/smilies/angry.png)
I poked around with a screw driver found loads of rust here there and every were (nothing that can't be fixed) then left it to have dinner.
Few hours later was board so decided to have another play and a hour and half later it was all stripped down.
![[Image: DSC_0464_zpsyllwhwa7.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0464_zpsyllwhwa7.jpg)
![[Image: DSC_0466_zpsu3eyazot.jpg]](http://i552.photobucket.com/albums/jj332/mazda_323f/Mobile%20Uploads/DSC_0466_zpsu3eyazot.jpg)
So list that it needs are as follows
2x tyres
Front and rear wishbone bushes
1 ball joint
Clutch (new one was with car)
Drivers side wheel bearing
plenty of welding
Front indicator
Front arch guards (is no arch guards an mot fail???)
Think that's everything but no doubt something else will crop up.
So plans are fit the gt20 off ash's estate with my arp's and just run a low tune so I don't kill clutch, hopefully make it alot more drivable with a gt20 on.
And hopefully get all this done before pugfest.
Comments welcome