02-06-2015, 07:22 AM
Managed to get the con rods fitted to the pistons.
Changed the piston rings too.
Did not mange to get them in the block as I was struggling with time.
Just hoping it all went right and I have done it correctly if I am honest.
Need to get a few seals and things before I crack on with putting things back into the engine, but that wont be this weekend as I am going up in a helicopter this weekend for a birthday present for my brother.
I am hoping to make a good go at finishing this near the end of June, as I am having a week off to stay at Kris's place to get some things done.
Changed the piston rings too.
Did not mange to get them in the block as I was struggling with time.
Just hoping it all went right and I have done it correctly if I am honest.
Need to get a few seals and things before I crack on with putting things back into the engine, but that wont be this weekend as I am going up in a helicopter this weekend for a birthday present for my brother.
I am hoping to make a good go at finishing this near the end of June, as I am having a week off to stay at Kris's place to get some things done.