01-06-2015, 09:23 PM
I will see how it goes, as it started ok with out any smoke earlier on there, that was when it was cold.
also tonight there, I have now switched from the pattern bin copy exhaust, to a nice stainless steel piper unit,
Got double check all is ok, as i might have a blow here and there, We had to make up a little extension pipe to bride a 6" gap, between the flexi and centre section, that's due to the subframe setup i am using.
i still got the quiet purr, under 4k after that it really wakes up, none of this chav warp i used to have, just that sports car warp after 4k rpm, the engine even revs more smoother too, in fact i think it runs better too.
only thing that cut everything short, was the f*cking weather turned! we ended up getting wind and fuckin rain!
got fuckin soaked while i was putting my little pipe extension. i had to tighten up under there while the ground started to flood in sections!
i will try and get some photos later on, once the weather stops been a rent boy.
also tonight there, I have now switched from the pattern bin copy exhaust, to a nice stainless steel piper unit,
Got double check all is ok, as i might have a blow here and there, We had to make up a little extension pipe to bride a 6" gap, between the flexi and centre section, that's due to the subframe setup i am using.
i still got the quiet purr, under 4k after that it really wakes up, none of this chav warp i used to have, just that sports car warp after 4k rpm, the engine even revs more smoother too, in fact i think it runs better too.
only thing that cut everything short, was the f*cking weather turned! we ended up getting wind and fuckin rain!
got fuckin soaked while i was putting my little pipe extension. i had to tighten up under there while the ground started to flood in sections!
i will try and get some photos later on, once the weather stops been a rent boy.