31-05-2015, 09:44 PM
Figured I'd compile at least a small update with only a week to go before FCS15 since a few things have happened.
I obtained another set of black masks from a friend as one of mine was pretty poorly done and letting moisture in, then what started as swapping them over ended in this:
Many 'might as well while it's off's later and me and my friend Niall had sanded and sprayed the slam panel and other metal engine bay parts, ripped the aircon out, and cleaned up the engine bay and radiator (which had loads of crap stuck in it from driving during floods last year)
We then failed massively by putting a Peugeot Sport sticker on upside down...
My rear beam decided it wanted to sound like a seal sanctuary the other day also so I took this opportunity to order a fully reconditioned GTi6 beam which will be lowered 60mm and fitted on polybush mounts when it arrives next week.
I'll be doing the front springs and struts as well as new wishbones which will be polybushed at the same time.
Today, thanks to Niall I managed to get a set of Morettes which I'd wanted for a while so I can run a proper cold air feed. Not sure if I'm going to keep just one or swap both as of yet...
I obtained another set of black masks from a friend as one of mine was pretty poorly done and letting moisture in, then what started as swapping them over ended in this:
Many 'might as well while it's off's later and me and my friend Niall had sanded and sprayed the slam panel and other metal engine bay parts, ripped the aircon out, and cleaned up the engine bay and radiator (which had loads of crap stuck in it from driving during floods last year)
We then failed massively by putting a Peugeot Sport sticker on upside down...
My rear beam decided it wanted to sound like a seal sanctuary the other day also so I took this opportunity to order a fully reconditioned GTi6 beam which will be lowered 60mm and fitted on polybush mounts when it arrives next week.
I'll be doing the front springs and struts as well as new wishbones which will be polybushed at the same time.
Today, thanks to Niall I managed to get a set of Morettes which I'd wanted for a while so I can run a proper cold air feed. Not sure if I'm going to keep just one or swap both as of yet...