(13-05-2015, 11:43 AM)Stef205 Wrote: Then the bar will be to high and the harnesses won't provide the support
The two bolts there on the C pillar, with a thick plate in place and bolted, the 48mm (2.5mm wall thickness) tube can be put level with the harness holes in the seats...so the harness would be level.
My plan, as seems dumdums too if he was to do so, is two bars from centre of the tube down to the lower seat mountings.
(13-05-2015, 08:09 AM)welshpug Wrote: no cage = no buckets = no harnesses.= perfect world
I will take a well secured and built harness bar with buckets in a stripped out car over a floppy seatbelt with a likely to fail pretensioner and unsupportive standard seats anyday.
Plus at least the OP, Puglove and myself are trying to come up with a safe solution over most of the muppets that bolt the harness straight down to the lower rear passenger seatbelt mounts.
Wishes for more power...