13-05-2015, 05:17 PM
(13-05-2015, 04:39 PM)JJ0063 Wrote: Good effort.
Get some Autosol from Poundland and give that tail pipe a going over with some wire wool.
Also get some Rover badges for the wheel trims.
New rear plate, you've replaced one but not the other.
White caps for the front number plate screws.
Bonnet alignment, look at drivers headlight and passenger side.
Is there no way you can re-route the wiring for the spot lamps?
Those bits would really finish it off.
the wiring has been re routed, sadly these lamps no longer work now, ( both f*cked)
no where local makes number plates up sadly, which is a bit of a pain! I will see what I can do with the tail pipe, as we may have some stuff here that bring that thing back up.
I do have some replacement wheel trims to go on this, I will try and dig those out tomorrow! I think its the angle i took the photo at, but i will check that too as it might be the lamps that are slightly out, ( a bit of adjustment)
Its come up alright hasn't it! i took your advise about the engine bay and we washed it and then gave it a bit of stuff on the pipes, not sure if we have something for the ECU and VVC lettering.
(13-05-2015, 05:07 PM)Toms306 Wrote: I think it is a new rear plate? Just not a quality one...
Pressed plates would look awesome on there though.
Does look good for it's age Procta!!
Now i have toyed with the idea of that tom, i might just do that! As i do have some plans for the bumpers and a new set of spot lamps. you wouldn't think it was 25 this year would you!
Its Worlds a part from the GTA isn't, this one is like years younger!