12-05-2015, 11:16 PM
(12-05-2015, 10:42 PM)Stef205 Wrote:(12-05-2015, 08:52 PM)Piggy Wrote: see you have the usual "you need this" chaps but then when you do "do this" the same chaps saying you can't and its not possible.
Puglove has done a decent job of this as have many others.
I will be doing similar. a 48mm steel tube, welded to two plates, bolted in on the C pillars on the two bolts either side where the seatbelt is bolted to normally.
A cage is great, but as with others £600 on a cage isnt going to happen.
Plus a bar in the right place and built well is 100 times better than bolting it down at an angle to the lower passenger seatbelt bolts which everyone stupidly does
no one said you cant do it, its not advised it is what was said also it should be cds tubing not any old tube. Just because others have done it and it "seems a decent job" doesnt mean it will hold up in a accident.
Is this the tubing I need for the harness bars on my cage?
https://www.merlinmotorsport.co.uk/p/cds...wwod4o8A9Q