06-05-2015, 10:38 AM
Cool thanks for the replies, will have to look into making the flywork or just get a new Rev counter.
I have the block back it was a few days late so no time to do anything before I went away to Dartmoor.
Will try and get it painted this week and then will start on the build up next weekend.
I was wondering if anyone could shed some light on the main bearings for me, on bearing one, I have noticed that there are seals on the side of the bearing did people change then when rebuilding? Also end float half-washers when I took the engine apart these just fell out so I am not sure which way around they go as I know they an anti-fiction face on one side.
I am sure when I have the crank in front of me the placement of these will be obvious but its nice to get a piece of mind from people who have already successfully rebuilt these engines.
I have the block back it was a few days late so no time to do anything before I went away to Dartmoor.
Will try and get it painted this week and then will start on the build up next weekend.
I was wondering if anyone could shed some light on the main bearings for me, on bearing one, I have noticed that there are seals on the side of the bearing did people change then when rebuilding? Also end float half-washers when I took the engine apart these just fell out so I am not sure which way around they go as I know they an anti-fiction face on one side.
I am sure when I have the crank in front of me the placement of these will be obvious but its nice to get a piece of mind from people who have already successfully rebuilt these engines.