Yeah, as above - as long as i drive it with half a brain and consciously avoid any body of water bigger than a small puddle it should be fine. Helpfully i found a bit of mesh in the scrap bin at work that was just big enough, another nice free fix. I've cut the bumper a bit more to tidy it up and plastic welded the mesh into the back of the bumper to keep it all in place:
[attachment=22423]
Those brakes Piggy mentioned that i've somehow failed to snap before now:
[attachment=22422]
All looking a bit busy over this side of the bay now:
[attachment=22424]
As you can see, i've now sorted out the intake tract and all of the coolant and boost piping, all that's really left to do in the bay is a bit more heat shielding and a wg control boost feed for the td05. The reshell is almost complete too, just a few odd bits to sort out like some washers for the exhaust flange, bleed nipples for the rear calipers, finish the centre console, quite a bit of wiring, etc. Also realised i've been a right mong and plumbed the brakes in side to side rather than cross-ways, if that makes sense, so that'll need fixing.
[attachment=22423]
Those brakes Piggy mentioned that i've somehow failed to snap before now:
[attachment=22422]
All looking a bit busy over this side of the bay now:
[attachment=22424]
As you can see, i've now sorted out the intake tract and all of the coolant and boost piping, all that's really left to do in the bay is a bit more heat shielding and a wg control boost feed for the td05. The reshell is almost complete too, just a few odd bits to sort out like some washers for the exhaust flange, bleed nipples for the rear calipers, finish the centre console, quite a bit of wiring, etc. Also realised i've been a right mong and plumbed the brakes in side to side rather than cross-ways, if that makes sense, so that'll need fixing.