Intercooler brackets

[Nathan1305]

To be honest, might as well use what you have, however I'm bored and feeling helpful...

A very crude image and only 2d but you should be able to workout happens happening from my project thread pic's and this diagram.

Definately not the best route, but works for me and I like it... All pipes are accesible and easily tightened except the turbo outlet one, but thats a b*tch however you decide to route it.



It requires:

(from turbo outlet to FMIC inlet)
2">2.25" 90 bend
2.25" straight length
2.25" 90* silicone bend
2.25" straight length
406 S shape FMIC pipe
2.25" straight length
2.25" 90* silicone bend
INTO FMIC INLET

(from FMIC outlet to engine inlet)
2.25" U bend silicone
2.25" straight length
2.25" silicone coupler
2.25" straight length
2.25" 90* silicone bend
2.25" 90* pipe
2.25" silicone coupler
2.25" straight length
2.25" 90* silicone bend
2.25" 45* pipe
2.25" silicone couple
INTO INLET

AS you can see, lots of bits, however it's tidy, certainly not a "bodge" such as some I've seen that run straight over the engine and fowl things including the bonnet and pipes themselves.

This all sits nicely and I had it all lying around from various builds.

In an ideal world you want minimal bends, as much pipe as possible (silicone is a weakness) and the shortest route possible.

Your kit looks quite good for those criteria, I'm sure it'll be fine!

That's awesome thank you  I'll have a look when it arrives and see what will work easier guessing to do the pipes to the turbo it will be easier to do when I remove the manifold