06-01-2015, 05:31 PM
Got a set of M12 x 1.25 24mm (measured from the taper) so should give me 21/22 mm thread which i hope is bang on right.
Got them from a helpful bloke who runs this place http://www.mtec-racing.com/
From what i could tell by randomly searching on ebay and the likes the standard tapered bolts for the 306 seem to be 28mm which is what i was supplied with. But ta for the suggestion.
I also picked up replacement mcgards (only Su's this time) for a bargain- which will help ease the cost of returning stuff!
Fingers crossed the lengths are okay. I guess if it's a tiny bit too long (which is my only concern) i will have to grind the end with something to remove a mm or so as i couldn't find anywhere selling 19mm m12 x 1.25 any shorter! And when i say grind....i'll probably just rub it on the pavement or something like that. (i'll add to the bodge thread nicely!)
Got them from a helpful bloke who runs this place http://www.mtec-racing.com/
From what i could tell by randomly searching on ebay and the likes the standard tapered bolts for the 306 seem to be 28mm which is what i was supplied with. But ta for the suggestion.
I also picked up replacement mcgards (only Su's this time) for a bargain- which will help ease the cost of returning stuff!
Fingers crossed the lengths are okay. I guess if it's a tiny bit too long (which is my only concern) i will have to grind the end with something to remove a mm or so as i couldn't find anywhere selling 19mm m12 x 1.25 any shorter! And when i say grind....i'll probably just rub it on the pavement or something like that.
(i'll add to the bodge thread nicely!)