should really start a project thread...

[toseland]

So.. toms306's er... 306, purchased and played and the bug of spending lots of pennies has well and truely started..

where i am at the moment
Stage 1+ Jammapic remap
Powerflow cat back stainless system (sounds LOVELY)
VTS front shocks (20mm lower)

now.. Dynoed today at

119.4hp/204.something ft/lb at the wheels, (not bad considering the boost leak)

this is with a slight (massive) boost leak, that i havent fixed because



in the next week or so

Performance
1. exhaust being sorted - cat removed to go with the nice powerflow backbox i have on there already (thanks toms)
2. boost gauge and manual boost controller being fitted
3. giant twinpass FMIC being fitted
4. boost being turned up to accomodate the smokeyness around 3000rpm, potentially to 17-18psi, maybe to 20

cosmetic
rear windows are being tinted the same shade of black as the heko wind deflectors

at some point: the wheels are being powercoated, the bonnet will be replaced (need a moonstone bonnet in good condition anyone?) need to get a halfrauds shopping list for the side of the car and some wolfrace 19inch alloys *ahem*


itll have a nice bit of servicing over the next few weeks too when i get time..


you can find the dyno graph and its lovely smooth curves