306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Vnt down the back of the engine

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vnt down the back of the engine
MarkHam Offline
I'm new, be nice
Posts: 62
Threads: 9
Joined: Feb 2013
Location: Broughshane / n Ireland
Car Model/Spec: 306 d-turbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
#11
08-09-2014, 07:20 PM
(08-09-2014, 01:46 PM)Ruan Wrote: Well, put it this way...

A GT2560R won't be on song until past 3200rpm at least.

A GT2260V will be on boost by 2600RPM - but you'll be limited by surge.

A GTB2260VK with the correct headwork will give you 28lbs of boost by ~2100rpm - again you'll be limited by surge, but the compressors are MUCH more surge resistant.

All of which will give you power to >5200RPM if the pump can keep up. Again, with correct headwork, a GTB2260VK is a 300hp turbo if you can deliver the fuel to it at the right time.

That's the info I was after. Cheers
Find
Reply
Thanks given by:


Messages In This Thread
Vnt down the back of the engine - by MarkHam - 08-09-2014, 10:58 AM
RE: Vnt down the back of the engine - by Piggy - 08-09-2014, 11:13 AM
RE: Vnt down the back of the engine - by Ruan - 08-09-2014, 11:14 AM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 11:28 AM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 01:20 PM
RE: Vnt down the back of the engine - by Ruan - 08-09-2014, 01:46 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 07:20 PM
RE: Vnt down the back of the engine - by padge - 08-09-2014, 02:19 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 06:47 PM
RE: Vnt down the back of the engine - by Dum-Dum - 08-09-2014, 04:51 PM
RE: Vnt down the back of the engine - by padge - 08-09-2014, 07:50 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 11:03 PM
RE: Vnt down the back of the engine - by Dave - 09-09-2014, 02:03 AM
RE: Vnt down the back of the engine - by MarkHam - 09-09-2014, 09:15 AM
RE: Vnt down the back of the engine - by anto - 15-09-2014, 12:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)