306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Vnt down the back of the engine

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vnt down the back of the engine
MarkHam Offline
I'm new, be nice
Posts: 62
Threads: 9
Joined: Feb 2013
Location: Broughshane / n Ireland
Car Model/Spec: 306 d-turbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
#4
08-09-2014, 11:28 AM (This post was last modified: 08-09-2014, 11:31 AM by MarkHam.)
Ok thanks. I will have a look out for daves.

Basically I have achieved 206bhp with an old waste gate turbo. I was hoping to make just a bit more power and wanted to get more power over the rev range.

I am deciding between a gt2560r which I already have but Also considering vnt now.

Would the gtb vnts be much benefit over the gt2560r?

Cheers
I think if I could get my hands on a gtb2260 I would try to make it fit down there. But I won't be cutting any of the car awaylol
Find
Reply
Thanks given by:


Messages In This Thread
Vnt down the back of the engine - by MarkHam - 08-09-2014, 10:58 AM
RE: Vnt down the back of the engine - by Piggy - 08-09-2014, 11:13 AM
RE: Vnt down the back of the engine - by Ruan - 08-09-2014, 11:14 AM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 11:28 AM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 01:20 PM
RE: Vnt down the back of the engine - by Ruan - 08-09-2014, 01:46 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 07:20 PM
RE: Vnt down the back of the engine - by padge - 08-09-2014, 02:19 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 06:47 PM
RE: Vnt down the back of the engine - by Dum-Dum - 08-09-2014, 04:51 PM
RE: Vnt down the back of the engine - by padge - 08-09-2014, 07:50 PM
RE: Vnt down the back of the engine - by MarkHam - 08-09-2014, 11:03 PM
RE: Vnt down the back of the engine - by Dave - 09-09-2014, 02:03 AM
RE: Vnt down the back of the engine - by MarkHam - 09-09-2014, 09:15 AM
RE: Vnt down the back of the engine - by anto - 15-09-2014, 12:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)