Engine swap questions

[Dave]

Cant remember what way around the pressure plate goes but do not put the car back down on the wheels with no drive shafts as they basically hold the bearings together. Ive seen people do this before, push a car about and half the hub falls off with the wheel and brake lol

Not quite sure this is right

Think you might be confused with the bearings on the driveshaft if you push the car around with the driveshafts in then the roller bearings from the driveshafts fall out if the shaft flexes too much in one direction. Ive pushed many 306's about with no shafts in and not had an issue.