306 2.0 hdi 16v

[jammapic]

i am putting 80 from 2250 up to 3500 rpm, and the axis on duration tables were extend to 1700 bar.
But still i am not a expert on mapping so maybe i can put a little bit more fuel.
My goal is to put 90mm^3 with the new 16v engine and 1700 bar with the 2.2 r70 pump if it can handle that pressure

I would say you can put a LOT more fuel, circa 25% more in through the midrange at that pressure. If you've extrapolated the duration tables out to your working pressure (i assume you did flow through an orifice calculations to give you the time in ms for the z values?) then it should be around 80mm^3 at the injector per stroke.

I'd be aiming for about 1.5bar boost and 100mm^3 with that current setup, which should give about 185 - 190hp at about 3500/3750rpm.

JP