06-03-2012, 08:55 PM
It's in the ally pipe, yea the silicone behind in the pic goes over but I'm not sure if it's enough.
It looks like a random hole? The boost gauge is tapped into the silicone at the inlet side. That pipes between the rad at the bottom.
I managed to get it boosting well today, flickered up to 19 ish a few times. I'm guns re route it tho the outlet pipes go infront and round the back of the rad so I want to get it up under the bonet catch this week.
We had a laser thermometer on the pipes and the air was coming out the same temp as it goes in the fmic so it's effectively pointless lol.
It looks like a random hole? The boost gauge is tapped into the silicone at the inlet side. That pipes between the rad at the bottom.
I managed to get it boosting well today, flickered up to 19 ish a few times. I'm guns re route it tho the outlet pipes go infront and round the back of the rad so I want to get it up under the bonet catch this week.
We had a laser thermometer on the pipes and the air was coming out the same temp as it goes in the fmic so it's effectively pointless lol.