A Street Sleeper is reborn! THE END

[procta]

right an update well more of a parts update.
when I was at work, my dad cracked on with the ****ed studs that were in the rear subframe mounts, we had visions of replacing those! That I think will be a bit of a **** on. as the bolts would be well on!
anyway, my dad managed to wind out the studs with a pair of mole grips and that was it done!
so the subframe can go back on the car!
also while I was at work, my dad managed to get the ends of the hold brake lines off the subframe, which is practically close of going on the car,



also heres the new handbrake cable hanging down ready to go on the car!




the tank in place!

and the fuel neck in place too!


I managed to keep the old red ring off the car so that I can colour code it when I get the body work done, but then again I may leave it black, just have to see!

here is something very cute for you! with it been a carbed spec shell, I decided to put the choke cable head back in, for show!


now some of the upgrades to this car,
1st up an upgrade that sorts out the door handles,
some of the earlier metros had metal door handles where the later ones had plastic that were known for failing!
So with my replacement one been ****ed too off the gta,
one of the lads from metro owners club from Malta sorted me out with a pair of metal ones, not bad for £13 quid posted!
need a paint up but who cares!

The braided hose kit that I was in too minds of doing with the gta, but now I have decided to implement this upgrade while this car is in bits,

Also another upgrade well a very rare OEM extra, that I wanted for the GTA, but for love of money would a pair come up! until a few days ago! So I snapped some light protectors, like I have on the 306.

Also got my poly bushes for the front end of the car, so that's the full works sorted now!
just need the hubs off the other subframe and swop them over.
Then the car is as good to go!
got my console to go in too, but I am looking into reworking that with new gauges and I will put my Hazard switch in there in stead of butchering the dash, also I may put the glove box light in, as that's still bugging me
We are very close on getting this sleeper sorted!