A Street Sleeper is reborn! THE END

[procta]

right here is todays little bit progress, not much but still. As this car has a few things that are damaged and I have good items on the gta.

lets start off with swopping over the boot stuff, With me removing the seat belts from the gta, I removed and swopped over the tool kit and spare wheel over, As this one has a skinny and the tool kit looks a bit ****ed, Well the wheel brace is.







Now I found that there are some major changes, with the gta/gti regarding some bits to the standard cars, the spare wheel securing bolt.
the standard ones are smaller as the wheel is thin, compared to the wider wheel.

luckly I took it off the gta and swopped it over.



then I fitted the boot light too, as this little car didn't have one, so that's now robbed off the gta, ( it will be wired in when I swop the looms over)

the ash tray took out of a rear side trim.



to go into here,



I swopped over my sunvisors as the ones on this car are ****ed, No photos as you cannot really tell anyway.

those who followed to 1st metro thread, will remember me putting a new bonnet release cable on, so I swopped that over onto this one







then I swopped over one of the front lights, as one looked tired and with me just buying new ones!


I may just swop over the passenger side, to keep things looking more cleaner,
but today has been mostly removing bits and pieces from the gta, I was going to start fitting in the seat belts but I want to give them a good clean.
I may start removing the electronics tomorrow from the gta, I will take one last video of the gta running before it powered off for good. If I can I will post in on the other thread.
But we are making very quick progress!