29-03-2014, 09:09 PM
Resistance should be very low, if it's high then there could be a bad connection somewhere.
I found today the the main engine loom plug on my hatchback doesn't screw to the body, very strange. I took it off today to check if there were any corrosion in there.
The pins the ecu end should be in the haynes manual, shit is it a three plug ecu on that? If it is I think Cully did a thread in the guides section on the pin outs on the three plug unit.
I found today the the main engine loom plug on my hatchback doesn't screw to the body, very strange. I took it off today to check if there were any corrosion in there.
The pins the ecu end should be in the haynes manual, shit is it a three plug ecu on that? If it is I think Cully did a thread in the guides section on the pin outs on the three plug unit.