23-03-2014, 05:41 PM
Am i missing something here, we are commenting on drums, but you cant even see the drum in the photo??
Tom, have you adjusted up the adjuster in the center of those drums until they just "scrape" the discs when there on? they still looking retracted right back to me?
Those liners look fine, loads of meat on them, was execting them to be slogged out, so jsut needs adjustment, but if it was me, id strip it right down, blow out the crap, and put grease on all the sliding surfaces, but tbh just blow it out, grease it up in the right places and adjsut it up...will be fine...and as Niall said, bleeding the brakes also wouldnt be a bad plan, not only to refresh the fluid but to work any air out, as some of your slack could be air in the line...but 90% of it is drum adjustment, trust me.
Tom, have you adjusted up the adjuster in the center of those drums until they just "scrape" the discs when there on? they still looking retracted right back to me?
Those liners look fine, loads of meat on them, was execting them to be slogged out, so jsut needs adjustment, but if it was me, id strip it right down, blow out the crap, and put grease on all the sliding surfaces, but tbh just blow it out, grease it up in the right places and adjsut it up...will be fine...and as Niall said, bleeding the brakes also wouldnt be a bad plan, not only to refresh the fluid but to work any air out, as some of your slack could be air in the line...but 90% of it is drum adjustment, trust me.
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
| #DervMafia |