20-03-2014, 06:18 PM
to finish off
here's the last part
sceince part3
now the parts are semi clean
bearings and the ABS sensors were removed
the ABS sensor came out without destroying it,
it is in one piece!
the last bit was to go over the hub with a drill with a wire brush attachment,
flushed it off with brake cleaner, quick wipe dry with a cloth mask up
then give it a coat of primer to stop them rusting again till i decide on colour
![[Image: DSCF1330.jpg]](http://img.photobucket.com/albums/v159/cully/Electrolisis%20cleaning%20of%20rusty%20car%20parts/DSCF1330.jpg)
![[Image: DSCF1331.jpg]](http://img.photobucket.com/albums/v159/cully/Electrolisis%20cleaning%20of%20rusty%20car%20parts/DSCF1331.jpg)
good as new just needs bearings pressing in
here's the last part
sceince part3
now the parts are semi clean
bearings and the ABS sensors were removed
the ABS sensor came out without destroying it,
it is in one piece!
the last bit was to go over the hub with a drill with a wire brush attachment,
flushed it off with brake cleaner, quick wipe dry with a cloth mask up
then give it a coat of primer to stop them rusting again till i decide on colour
![[Image: DSCF1330.jpg]](http://smg.photobucket.com/user/cully/media/Electrolisis%20cleaning%20of%20rusty%20car%20parts/DSCF1330.jpg.html)
![[Image: DSCF1331.jpg]](http://smg.photobucket.com/user/cully/media/Electrolisis%20cleaning%20of%20rusty%20car%20parts/DSCF1331.jpg.html)
good as new just needs bearings pressing in