12-03-2014, 09:08 PM
(This post was last modified: 12-03-2014, 09:10 PM by Rippthrough.)
Err, just looking at your bushes for the pivots - why have you got no crush tubes?
You're not going to just try to let it pivot on the bolt are you?!
And be very careful using the outer rose joints in shear like that, generally they need to be very oversized to last as the stress concentration across the thread root means the fatigue rate is insane.
You're not going to just try to let it pivot on the bolt are you?!
And be very careful using the outer rose joints in shear like that, generally they need to be very oversized to last as the stress concentration across the thread root means the fatigue rate is insane.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.