Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cluskies ph3 hatch
#3
Space those wheels out too buddy, the 206 runs about 10mm smaller offset than a 306 so the wheels tend to get lost in the arches (at least that's how it looks from here)

Some 10-20mm spacers will look sweet on there.

If it is the 1.8 then I wouldn't go the decat route - makes a lot of noise but loses you noticeable torque, meaning you really have to wind the engine round to get anywhere. This means you get shite MPG because you're always thrashing it and you can't have a properly relaxing drive. It can also upset the Lambda sensor.
Disclaimer: The above is not to be taken to heart and is probably a joke, grow up you big girl.
[Image: Sig500x130.png]
Reply
Thanks given by:


Messages In This Thread
Cluskies ph3 hatch - by cluskie - 02-03-2014, 08:13 PM
RE: Cluskies ph3 hatch - by 7057sam - 02-03-2014, 11:47 PM
RE: Cluskies ph3 hatch - by C.A.R. - 03-03-2014, 10:58 AM
RE: Cluskies ph3 hatch - by cluskie - 03-03-2014, 06:22 PM
RE: Cluskies ph3 hatch - by Eeyore - 03-03-2014, 07:08 PM
RE: Cluskies ph3 hatch - by cluskie - 04-03-2014, 09:38 AM
Cluskies ph3 hatch - by devils_fuel - 04-03-2014, 09:56 AM
RE: Cluskies ph3 hatch - by cluskie - 05-03-2014, 12:22 PM
RE: Cluskies ph3 hatch - by jonas306 - 05-03-2014, 08:19 PM
RE: Cluskies ph3 hatch - by Piggy - 05-03-2014, 08:23 PM
RE: Cluskies ph3 hatch - by cluskie - 06-03-2014, 10:56 AM
RE: Cluskies ph3 hatch - by C.A.R. - 07-03-2014, 10:00 PM
RE: Cluskies ph3 hatch - by cluskie - 15-03-2014, 07:38 PM
RE: Cluskies ph3 hatch - by cluskie - 08-06-2014, 09:52 AM
RE: Cluskies ph3 hatch - by Strikeforce - 08-06-2014, 11:46 AM
RE: Cluskies ph3 hatch - by cluskie - 08-06-2014, 06:54 PM
RE: Cluskies ph3 hatch - by willJspears - 08-06-2014, 10:32 PM
RE: Cluskies ph3 hatch - by mcvite - 08-06-2014, 11:04 PM
RE: Cluskies ph3 hatch - by 7057sam - 09-06-2014, 05:22 AM
RE: Cluskies ph3 hatch - by C2K - 09-06-2014, 06:42 AM
RE: Cluskies ph3 hatch - by cluskie - 09-06-2014, 09:23 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)