08-02-2014, 12:39 AM
(08-02-2014, 12:05 AM)Rippthrough Wrote:(07-02-2014, 09:57 PM)Tom Wrote: So basically weld a few pins onto the selector forks and machine a drum then gogogogo???
And remove the synchro's, and rings, have a full dog-engagement gearset and selector rings machined. And mod the casings for bearings for the selector shaft, if you can even fit it in.
May as well just buy a dog box by the time you've done.
Calm down.. its a bit of fun
I'm trying to do this cos I'm a lazy. not for SUUPER DOOPER fast gear changes at 12k rpm oh wait its a car engine. I mean 1.2k rpm
syc-mesh will do.. hopefully...
...85cc Petrol 0 Doors... - ...135MPG... - ...£17 Tax...