03-01-2014, 12:03 AM
(This post was last modified: 03-01-2014, 12:04 AM by tysonbully2k12.)
(02-01-2014, 11:58 PM)ally406 Wrote: It's 99% the same, the ECU on the 406 doesn't really do much, it can apply some injection advance (up to 20 degrees) based on information from the needle lift sensor on the injector, temperature sensor and crank position sensor. Likely you will want to swap the pump for a pure mechanical pump to make life easy, you can leave everything else as is I would think. The injector with the needle lift sensor will work fine without the sensor being plugged in.
So all i will have to do is change the pump? Will it all still plug into the passenger side wiring socket thing? Its going in to a hdi.
(03-01-2014, 12:02 AM)jammapic Wrote: I can vouch for this, it's what I ran in my old xud.
Did you have to change anything else except the pump? And does it plug straight in?
![[Image: 13073041_458228241037318_1249062425_o_zpsoh6qf7gu.jpg]](http://i1281.photobucket.com/albums/a520/martynharvey/13073041_458228241037318_1249062425_o_zpsoh6qf7gu.jpg)