22-12-2013, 05:31 AM
(22-12-2013, 12:33 AM)titch Wrote: Just a quick question when re fitting the new hub how do you correctly align it?
Titch
umm not sure what the question is referring too
the complete hub slides onto the shock tube until it hits the stop alignment pin on the back of the shock tube
the TRE only fits into a hole on the hub and has a nut to secure it
and the lower ball joint slides in enough to insert the locking pinch bolt
the drive shaft slides into the hub bearing and the 35mm nut pulls it tight
be carfull not to pull the driveshafts out the gearbox or you will loose gearbox oil