27-11-2013, 03:11 AM
So i got a new gov that was shimmed about 6mm with a nut, tried to put the pump back together and the gov kept coming out of the cradle, found out this is why:
![[Image: 1463119_10153478359285062_1986759318_n.jpg]](https://scontent-a-lhr.xx.fbcdn.net/hphotos-ash3/1463119_10153478359285062_1986759318_n.jpg)
That was annoying, but i still had the gov that i broke so a replacement was there
Then did this:
![[Image: 1452427_10153478359325062_294697214_n.jpg]](https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-ash4/1452427_10153478359325062_294697214_n.jpg)
The spring is a bit smaller than 1/2 the size of the standard gov spring, and a little bit softer, any ideas if that will cause me any problems? Couldnt fit the standard spring back on so rummaged through my collection of crap and put this together...
That was annoying, but i still had the gov that i broke so a replacement was there
Then did this:
The spring is a bit smaller than 1/2 the size of the standard gov spring, and a little bit softer, any ideas if that will cause me any problems? Couldnt fit the standard spring back on so rummaged through my collection of crap and put this together...