26-10-2013, 07:01 PM
Personally i would work out how much all those elbows and stuff is going to cost then compare it to a flexi pipe.
Flexi pipe would be reducing 90 from your turbo inlet size to 3" then an ali 3" joiner then 3" flexi. Thats a whole lot less stuff than doing it with hardpipes.
Check out this stuff: http://www.autosiliconehoses.com/silicon...etres.html Just over 20quid a meter. This is what i would do though, if you want to go hardpipe, theres nothing wrong with that, just theres more pieces and it might be more expensive.
Flexi pipe would be reducing 90 from your turbo inlet size to 3" then an ali 3" joiner then 3" flexi. Thats a whole lot less stuff than doing it with hardpipes.
Check out this stuff: http://www.autosiliconehoses.com/silicon...etres.html Just over 20quid a meter. This is what i would do though, if you want to go hardpipe, theres nothing wrong with that, just theres more pieces and it might be more expensive.
Doesnt even own a 306.
