(21-10-2013, 07:42 PM)Jonny81191 Wrote: A word of warning regarding the bottom mount: Do NOT use a rubber mallet as a "solid" bottom mount, it'll crack in under a week of use and will be rendered useless.not sure I fully understand your point
(21-10-2013, 07:52 PM)Grant Wrote: Just out of interest, what resin did you use?
A few years ago I approached some polyurethane resin suppliers for samples, basically I contacted their marketing people told them I intended to make some custom poly bushes and asked for a sample, one company John Burns were very helpful and agreed to send samples of the most appropriate resins, I expected some little pots but they sent a big box of 3 different resins, probably 6 litres in total, after a bit of trail and error I made some bushes for a Impreza race car I was building, the actual product is called Ultra Cast 10/95 and seems to do the job just fine. The result is I’ve still got quite a bit left over, I was worried that the resin may have ‘gone off’ because it’s just been sat in the garage for the last couple of years but it seems to be fine, so it’s a big thanks to John Burns
