MG ZR: Cams & Maps

[procta]

Very highly strung, but I'll be dammed if I won't try and get more out of it
Been looking into reprofiled vvc cams, apparently there's a company in kent doing it
http://forums.mg-rover.org/showthread.ph...823&page=3
Wouldn't be cheap but holds onto the vvc mech, however it won't be done until the current engine is running right

Would like to fix this block first, because if I do decide to swap out the lump I can then get a pretty penny for the vvc block

get every thing ironed out 1st before you start upgrading stuff. also id watch it buying second hand vvc engines aswell, I was sold a dud!