06-10-2013, 01:39 PM
Very highly strung, but I'll be dammed if I won't try and get more out of it 
Been looking into reprofiled vvc cams, apparently there's a company in kent doing it
http://forums.mg-rover.org/showthread.ph...823&page=3
Wouldn't be cheap but holds onto the vvc mech, however it won't be done until the current engine is running right
Would like to fix this block first, because if I do decide to swap out the lump I can then get a pretty penny for the vvc block
Been looking into reprofiled vvc cams, apparently there's a company in kent doing it
http://forums.mg-rover.org/showthread.ph...823&page=3
Wouldn't be cheap but holds onto the vvc mech, however it won't be done until the current engine is running right
Would like to fix this block first, because if I do decide to swap out the lump I can then get a pretty penny for the vvc block
![[Image: mcetg0.png]](http://i57.tinypic.com/mcetg0.png)