03-09-2013, 10:01 PM
Dremel can't cut a slot because it's a rotary tool with round cutting blades, would hit the thread before getting all the way through the washer. Used tons of heat lol. Can't leave it because i've mashed it so much and it was leaking before.
Got it out! Drilled a hole in the outside edge, wedged a screwdriver against the inside edge on the same bit that was drilled, then applied pressure and tapped the shaft side-on a few times to shock it, popped out on the fourth hit.
Got it out! Drilled a hole in the outside edge, wedged a screwdriver against the inside edge on the same bit that was drilled, then applied pressure and tapped the shaft side-on a few times to shock it, popped out on the fourth hit.