205 DT sleeper - boosting video pg10 and pg11

[ginge191]

as requested


Elbow on turbo



And as you can see, the fouling on the turbo. Options are to either grind away part of the turbo, OR (a better idea) make a plate up to bring the elbow out by 25mm or so. With this plate, bore out the mounting points allowing some rotational movement on the elbow, bringing the compressor side in line to take standard IC piping.




And finally, the new bonnet, not to everyones taste; but should do the job and a cheap price, i can't complain. just now to chop some holes for the bonnet pins