27-07-2013, 08:13 PM
Is the centre pin a bit to big for the bushes? You could drill the centre of the bushes out a bit bigger to allow them fit a bit better.
Or you could try wedging it into the subframe with a pry bar, if you put the end of the bushing that is sitting correct into the subframe at a bit of an angle and the put the tip of the pry bar on the subframe and push against the other bushing that needs compressed in.
Or you could try wedging it into the subframe with a pry bar, if you put the end of the bushing that is sitting correct into the subframe at a bit of an angle and the put the tip of the pry bar on the subframe and push against the other bushing that needs compressed in.