14-07-2013, 04:07 PM
And I get annoyed with you because if I miss ONE SINGLE FRIGGING THING you get on my back like theres no tomorrow. I am not a frigging computer you know I cannot remember or read 100% accurately! I need to cut the track rod end so that I can get the special tool over the track rod, otherwise the track rod end will prevent me from getting the tool over the track rod.
As for reading again I am guessing this is the post to which you are referring:
I am finding it hard to visualize what you mean by flicking out the teeth. And I can't see a securing ring either. I really don't want to damage the steering rack. I'm not ignoring what you are trying to tell me but if I don't understand a post I tend to forget about it completely. IT IS NOT DELIBRATE!!!
As for reading again I am guessing this is the post to which you are referring:
(14-07-2013, 09:19 AM)Piggy Wrote: shouldnt really use heat on steering components thus probably want to renew it anyway.
its not difficult...just tricking and difficult with space.
remove the boot.
use a screwdriver to try and flick out the 'teeth' on the securing ring and then either some hefty grips to undo it or use a good chisel to get it moving then grips after that.
I am finding it hard to visualize what you mean by flicking out the teeth. And I can't see a securing ring either. I really don't want to damage the steering rack. I'm not ignoring what you are trying to tell me but if I don't understand a post I tend to forget about it completely. IT IS NOT DELIBRATE!!!