Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Headgasket help/ Engine rebuilding Q's/Bad to f*cking worse.
#13
(07-07-2013, 10:56 PM)Tom Wrote: Skimming pistons good or bad idea? Trying to make life easier on the rods/headbolts

Also honing bores? Must or not so much? Surely if the same rings go back its not that major?

I'm not sure about skimming the pistons but I would say you should hone the bores. I would say fit new rings as well TBH but it depends how much money you want to chuck at it
Reply
Thanks given by:


Messages In This Thread
RE: Headgasket help - by darrenjlobb - 06-07-2013, 05:33 PM
RE: Headgasket help - by Tom - 06-07-2013, 05:43 PM
RE: Headgasket help - by Coc-ker - 07-07-2013, 09:22 AM
RE: Headgasket help - by Tom - 07-07-2013, 10:40 AM
RE: Headgasket help - by Coc-ker - 07-07-2013, 12:08 PM
RE: Headgasket help - by Tom - 07-07-2013, 12:12 PM
RE: Headgasket help - by Coc-ker - 07-07-2013, 12:15 PM
RE: Headgasket help - by Tom - 07-07-2013, 12:27 PM
RE: Headgasket help - by Coc-ker - 07-07-2013, 12:35 PM
RE: Headgasket help - by Tom - 07-07-2013, 01:50 PM
RE: Headgasket help - by Tom - 07-07-2013, 10:56 PM
Headgasket help/ Engine rebuilding Q's - by Frosty - 08-07-2013, 06:07 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  MLS headgasket enquiries. 205dtub 14 4,618 18-02-2015, 11:56 PM
Last Post: vinny
  Headgasket failure? AdamInNi 3 1,529 31-08-2014, 10:16 PM
Last Post: AdamInNi
  headgasket ? Teddy 6 2,167 23-04-2014, 02:57 PM
Last Post: Paul Baldwin

Forum Jump:


Users browsing this thread: 6 Guest(s)