01-04-2013, 09:24 PM
Well as I'm sure most have seen by now, the engine is out after being blown to bits.
http://306oc.co.uk/forum/thread-12448-po...#pid243938
Next week I'm heading up to sams to tackle the rust in the engine bay, then a full Hammerite job
Will hopefully have the new engine fitted by end of may complete with solid lower mount, decent front shocks, new rear beam, new discs pads all round, braided brake lines all round, calipers reprinted, and a general repaint.
Then it's mot time!
http://306oc.co.uk/forum/thread-12448-po...#pid243938
Next week I'm heading up to sams to tackle the rust in the engine bay, then a full Hammerite job
Will hopefully have the new engine fitted by end of may complete with solid lower mount, decent front shocks, new rear beam, new discs pads all round, braided brake lines all round, calipers reprinted, and a general repaint.
Then it's mot time!
TEAM CONROD SHITTING RALLYE!