03-02-2013, 09:48 PM
hi guys so need a loom for my car the engine that is! when my engine blew upon disconnecting everything i noticed that the loom had loads of burnt and frayed bits as i knew the engine was running 100% with everything working previous so all i done was cut off the burnt bits and taped what i could,
once installing the engine again and connecting everything up went to start her up and nothing no heater light and no turning over heart sunk thought sh1t so all i done was run a 2 wires inside one from the heater plugs and one from the starter to 2 push buttons i have the car going now but would ideally like it back to normal as its a bit of a bodge lol
phew long post for a small question
.
what looms fit the xud dt been ringing around here and getting silly quotes like 40,60 will the loom from a ph2 nad fit can get a hold of one of them for 25
once installing the engine again and connecting everything up went to start her up and nothing no heater light and no turning over heart sunk thought sh1t so all i done was run a 2 wires inside one from the heater plugs and one from the starter to 2 push buttons i have the car going now but would ideally like it back to normal as its a bit of a bodge lol
phew long post for a small question
.what looms fit the xud dt been ringing around here and getting silly quotes like 40,60 will the loom from a ph2 nad fit can get a hold of one of them for 25