Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RE: Low idle... constantly cutting out ------ FIXED!!!! :D
#1
sorry for keep posting my faults up, im at my wits end with the car at the minute, its doing my head in

basically i got it going earlier this week, its been fine for the past 3 days, but today it cut out on me again, i noticed it was running dodgey, when the revs dropped from 1000 to 800, and hesitated when i went to rev.

ive changed the fuel filter, but still no change, at one point i had my foot flat to the floor, for a good 10 seconds and it continued to stay at 800 rpm....

also ive noticed that the hand primer is soft, i pump it quite a few times, and it goes hard, but if i continue to pump it, it goes soft again, then takes ages to then go hard.....
while the primer is hard, i can hear the fuel in the pump, i dont know what its doing, but ive never hear it before.... ive had no end of trouble since running it on veg, and i dont know what else to do...

i apologise if im being annoying with my problem posts, im quite mechanically minded, but i dont really know much about these engines Smile

thanks, adam
Reply
Thanks given by:


Messages In This Thread
RE: Low idle... constantly cutting out ------ FIXED!!!! :D - by Adam.M.Penny - 31-01-2013, 11:08 PM
RE: Low idle... constantly cutting out - by Ricky - 31-01-2013, 11:11 PM
RE: Low idle... constantly cutting out - by Tom - 01-02-2013, 09:14 AM
RE: Low idle... constantly cutting out - by Tom - 01-02-2013, 10:27 AM
RE: Low idle... constantly cutting out - by Ruan - 01-02-2013, 12:08 PM
RE: Low idle... constantly cutting out - by Piggy - 02-02-2013, 07:21 AM
RE: Low idle... constantly cutting out - by kingy - 03-02-2013, 01:38 PM
RE: Low idle... constantly cutting out - by Piggy - 02-02-2013, 12:27 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Glow plugs on constantly bashbarnard 7 2,956 10-07-2015, 03:33 PM
Last Post: bashbarnard
  erratic idle / cutting out adamm306 39 7,567 25-02-2014, 07:35 AM
Last Post: Paul_13

Forum Jump:


Users browsing this thread: 7 Guest(s)